Tractor Talk Discussion Board |
Re: Re: Re: Stolen Money
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on December 16, 2002 at 01:18:38 from (209.23.145.21):
In Reply to: Re: Re: Stolen Money posted by FLYIN G on December 15, 2002 at 17:44:27:
In your very first message you said you picked up the tractor. Looking it over that may have been a typo? Anyhow, it's a tough situation. Seems like both sides didn't quite get what they wanted. A lot of dealers really get jerked around & are left holding the bag too. So, if he got frustrated with you, I can see a little of his point. And, I see your point too. Something that would be fair is, whenever he sells off the tractor, or tractor parts, & gets what you were offering for it, he refunds your money. That way you minght have to wait a while to get it back, but he had to wait a while too to get paid, & his inventory was tied up too waiting for you. Just kind of a tough deal, Maybe you were a little late & he was a little fast, who should we blame? Probably best to make these transactions face to face - money down & waiting a month seems to give room for bad deals on both sides, as we see here over & over. The lesson of hard knocks. Saturday I was in a hurry to get the snow blower in the shed at dusk, & stepped into a very long rusty nail - almost came out the top of my foot. Talk about learning hard lessons. I'd rather have lost the $500 you did & not stepped on the %^&* nail.... Makes what's important a little clearer sometimes. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|