Tractor Talk Discussion Board |
Re: j.d.brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by davidval on January 20, 2003 at 09:45:30 from (80.230.188.76):
In Reply to: j.d.brakes posted by Ian on January 20, 2003 at 08:21:54:
some jd models have power brakes (brake pressure prvided by the main hydraulic pump),other models have 'master cylinder' brake system. in power brakes,diconnect brake line at tha rear and put in a container.start the engine and depress the relevant brake pedal,there should be a high speed flow out of the line as long as the pedal is depressed. if there is,plug the line with a proper plug (or a 3/8nf bolt with a small bearing ball).the pedal should be high and strong (with the engine running!). if so,you have leakage at the brake pistons area. if not, the problem is within the brake valve or high pressure hydraulics. in the master cylinder system, the reservuir is filled by the tractors low pressure system(rear pump).you have to make sure the cylinder is filled with oil. on older models there is a large plug on the brake cylinder housing. open it and see if it's full. if it is, disconnect one of the lines at the cylinder and plug the nipple. when you depress the relevant pedal it should have little movement and then stop. if the pedal goes all the way down there is a problem within the brake cylinder.if not there is a leakage in the brake piston area. all these checks should be carried out on both sides. by the way usually problems begin in one side. you should try to activte one side at a time. if the problem is only in one side, make these checks on the bad side david
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|