Tractor Talk Discussion Board |
Re: ALLIS CHALMERS GENERATOR WIREING
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on January 30, 2003 at 10:48:56 from (165.170.128.68):
In Reply to: ALLIS CHALMERS GENERATOR WIREING posted by DON PRESTON on January 29, 2003 at 19:23:19:
Dale - If your Allis has a Delco generator, the cutout gets wired up as follows: - GEN terminal to generator "A" terminal - BAT terminal to the side of the ammeter that's NOT connected to the battery. The cutout base must be grounded for it to work. The generator "F" terminal should go to an auxiliary (or charging control) terminal on the headlight switch. The position of the light switch then determines whether the generator charges at a low or high rate. Note - the light switch must be in good condition, and solidly grounded in order for the generator to work. However in a pinch you can simply ground the generator "F" terminal and the generator will charge at it's highest rate. You just have to watch the battery to make sure it doesn't get overcharged and boil the electrolyte out!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|