Tractor Talk Discussion Board |
Re: Re: 6 volt to 8 volt system
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jimbob on January 31, 2003 at 08:22:46 from (207.89.249.41):
In Reply to: Re: 6 volt to 8 volt system posted by IH Man on January 31, 2003 at 05:00:40:
I agree, 8 volts is easy. Use a dropping resistor for lights & coil. I am just fine with the older points system. I would like to know the cold cranking amps at 6vdc & zero degrees F of a 172 cu. in. Ford gasoline engine. It should be close to double using 12 vdc. I guess I just would not want to be using the 6 vdc starter on 12vdc for over 5 seconds- usually plenty of time to start an engine in warmer weather. All starters are not the same either, perhaps the Ford starter has higher resistance windings & 12 vdc is no big deal. Tnx all.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|