Tractor Talk Discussion Board |
Re: Can I put High Detergent 10W-30 in my Farmall H?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ludwig on February 12, 2003 at 07:08:23 from (141.154.121.183):
In Reply to: Can I put High Detergent 10W-30 in my Farmall H? posted by DWeeb on February 11, 2003 at 19:34:31:
I did the switch on my '52 Super M last summer, one thing I need to do now is drop the pan and scrape the sludge out. The manual actually has a service interval for that... So in your case if you have a warm place you can work on it (I don't) pull it in, drop the pan, scrape the sludge, remember to clean the pickup. Put the pan back up, change the filter, fill with whatever sort of detergent oil you think is best. I'd probably start with a normal detergent oil like car oil. High detergent oil is usually a diesel oil, you can go to that if you want but I'd start with something gently detergent and then move up. Start 'er up. Run for a bit paying close attention to the oil pressure, then after a couple hours easy running, change the oil and filter again. Then plan on another change at maybe 10 hours. Pan gaskets are cheap so at the second change you might drop the pan again and again check the pickup. This would give good piece of mind too, a clean pickup would tell you everything was going well. When I did it I ran half detergent and half non because we ran out of detergent and didn't have time to go to Walmart 20 miles away. Ran it for about 10 hours mowing, everything went fine. In the spring I'll start it up and get it warm and do as I described above.
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|