Tractor Talk Discussion Board |
Re: Tractor PTO's
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD70Jim on February 14, 2003 at 07:15:54 from (12.215.70.158):
In Reply to: Tractor PTO's posted by Christine on February 13, 2003 at 14:37:29:
Christine: Your question is one of those which when asked (in innocence,by someone who has no idea at all) of someone who uses the equipment, causes hysterical laughter---all at your expense! It isn't your fault that they laugh, but the question is, to them utterly simple! I will, however, explain. A power take off, commonly refered to as a PTO, is a rotating shaft, usually 1 3/8" in diameter, with splines on it, located just above and in line with the tractor drawbar. It transfers power from the tractor engine (just like the driveshaft on a car or truck) to the towed or mounted implement. The splines on the shaft match the splines on the implement's driveshaft and there will be a device to lock the connection so that the driveshaft won't come off while operating, but can be disconnected easily when unhooking the implement. There are also "mid mounted" pto and "front" pto locations on some tractors. The "Mid" or middle mounted pto is also in line with the centerline of the tractor, but faces forward and is located under the tractor. but in front of the rear axle and under the transmission. Much more rare would be a "front" pto, which would be located between the front wheels, in front of the tractor and would be used with very specialized equipment. Front pto is highly uncommon. Does this answer the question? Good luck with the Horse Farm Management class.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|