Tractor Talk Discussion Board |
Re: TO-20 FERGUSON
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on February 22, 2003 at 18:43:13 from (205.188.209.109):
In Reply to: TO-20 FERGUSON posted by Jeffery Johnson on February 22, 2003 at 15:01:03:
Does your lift raise in a jerky motion? or smooth, but just won't stay up? Each of these are important. You can buy a kit that is not all that exensive. You might as well convert it from the old steel ring piston to the later O ring type while you.re at it. Make sue you honme the cylinder out good. Those steel rings leave some sharp edges, Drain the oil, pull the PTO shaft, remove both of the left and right side covers (PTO lever on the left) Drop the pump out of the bottom. Replace the relief valve, clean the pump and the poppett valves in the pump. If it lifts in a jerky motion, one of these is usually stuck open. Do one step at atime and everything will fall into place. If you want to convert your olddraft control only lift to a draft and position control, I have seen ZANE THANG ADvertise a kit for this changeover. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|