Tractor Talk Discussion Board |
Re: Planting Crops
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rev JJ on February 27, 2003 at 07:46:22 from (172.162.206.241):
In Reply to: Planting Crops posted by T_Bone on February 27, 2003 at 03:59:38:
Ten years ago, I was an early advocate for a no-till program; being a dealer forUFT had a little to do with it. What I have found to be the case is this; All things being equal, the only savings no-till offers is in time/labor, not in cash outlay. In North Texas conditions, the lack of tillage must be made up with a cash outlay for chemicals. it is not unusual to spray more than twice. in other words, especially for smaller operators, you can either invest your money in fuel to cultivate&plow and pay yourself to run the tractor, or pay the chemical bill and the spray man. If you already have a set of cultivators, plows, ect, I really think that the old way may be just as good if not better for many operations. Since fuel is so much higher of late, the above economics may be a little different, but not much. And if contour farming methods are used (remember them?) on rolling areas to minimize runnoff, the lack of chemical use is more environmentally sound as well.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|