|
Tractor Talk Discussion Board |
Re: Pray for peace
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on March 07, 2003 at 17:21:59 from (206.106.139.74):
In Reply to: Pray for peace posted by Gary in TX on March 07, 2003 at 17:13:53:
Gary, I also believe that we should pray for peace, but I also believe that we will never know true peace as long as there are individuals out there that wish to destroy our country and way of life. Unfortunately, the only way to expose those individuals and prevent them from harming us is through war. Everybody has their own opinion on fighting terrorism and the problems in the Middle East, but the fact is that all the diplomacy and peace demonstrations in the world will not capture Osama bin Laden or remove Saddam Hussein from power, and that's where we come in. I don't like the idea of U.S. troops going into harm's way, but that's what they train for and what we pay them for, and I'd rather have them hunting down and eliminating those that would kill us than have those devils planning the next 9/11. That said, I will be praying for peace. But I'll be praying much harder for the safety and security of our armed forces worldwide. I might even throw in a small one for Osama, Saddam and all the others that wish to see the end of American civilization, because I don't see their souls receiving much mercy where they'll hopefully end up. My two cents.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
