Tractor Talk Discussion Board |
Re: Off-the-wall question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on April 14, 2003 at 18:15:05 from (12.148.160.138):
In Reply to: Off-the-wall question posted by F14 on April 14, 2003 at 17:05:17:
Hi F14, I'll give you the numbers for my AC-B. Others may be different. Belt pulley speed:engine speed ratio = 0.75 Pto speed:engine speed ratio = 0.4 At a full load governed engine speed of 1400 rpm this yields 1050 rpm for the belt pulley and 560 rpm for the pto. My cordwood saw is driven off the 8" dia belt pulley by a speed-up drive (6" dia driven pulley) to yield a saw rpm the same as engine rpm. The belt speed at 1400 engine rpm with the 8" dia drive pulley is therefore about 2200 FPM. I use a 29" dia saw. At 1400 engine rpm, this saw is going about 10,600 SFPM which is really too high for that application. For sawing, I usually run at about 1/2 engine throttle to give something in the vicinity of 7,000 SFPM. I have found this to be a good wood cutting speed. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|