Tractor Talk Discussion Board |
Re: Injector Pump, Help Needed
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick L on May 19, 2003 at 12:52:08 from (64.209.59.111):
In Reply to: Injector Pump, Help Needed posted by Oldfarmboy Jim on May 18, 2003 at 21:50:17:
Make sure you have all the air out of the filter. I have in the past thought I had the air out of the filter and after cranking and not getting fuel to come out of the lines where they fasten to the injectors, reblead the filter and found lots of air bubbles comming out. After I remove and replace an injector pump I leave the lines loose at the injectors and crank untill I get fuel squirting out and then tighten. Most of the time one will clear first and I tighten that one and crank some more and then tighten the next on that clears all air. Two weeks ago I put new shaft seals on a ford 961 with the roosa master injector pump. The battery was dead and I had my son chain pull me about 100 yards. tightened all four lines and he pulled me about two feet and she was running. Didn't even sputter or slow RPM's down as usual when a little air clears thru.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|