Tractor Talk Discussion Board |
Re: Re: Re: '51 8N 3pt levers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sue on May 30, 2003 at 11:05:04 from (152.163.252.71):
In Reply to: Re: Re: '51 8N 3pt levers posted by Mike Johnson on May 29, 2003 at 09:53:07:
Thanks for the info guys. Makes a bit more sense now. Still have a bit of a problem with getting the brush hog to return to a set position after raising it to avoid an obstacle. We seem to have to raise the brush hog up all the way and then move the lever a little past the stop and then up onto the stop to maintain the same position we had before. Is it possible to just raise the hog up just a little and then back to the original position without monkeying with the lever so much? After mowing a bit more, I can see where the PTO override clutch would be handy. Thanks for any addtional info. Sue
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|