Tractor Talk Discussion Board |
Re: Extending a PTO shaft?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on June 14, 2003 at 21:10:25 from (12.148.160.138):
In Reply to: Extending a PTO shaft? posted by Les...fortunate on June 14, 2003 at 17:54:16:
Hi Les, Paul makes an excellent point about side load caused by the torque arm. You certainly can get extension shafts of a fixed length (female to male) that extend the shaft about 4 inches (as I recall). You could also make whatever length you need with a splined shaft section and a coupling. I would be concerned though about not running true due to clearances involved and the increased overhung side load caused by the torque arm. It could work but is surely not desirable. To do it well is likely more work than it's worth. My gut feel is to simply remove the shield and be done with it. It's not like there is a rotating U-joint or exposed mechanism that could represent a safety hazard. If you want or need to swap out your pump between tractors and use your pto for conventional shafting, it would not appear to be that big a deal to also reinstall the shield as needed. I have used the double U-joint arrangement that Paul mentions on a front hydraulic pump. It works great. You can use a close-coupled yoke to minimize the length of the two joints. That would work for you if you hard-mounted the pump. You'll have to decide if coming up with such a rig is worth not having to remove the shield. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|