Tractor Talk Discussion Board |
Re: Engine swap or rebuild?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wdTom on July 10, 2003 at 17:05:29 from (155.212.222.117):
In Reply to: Engine swap or rebuild? posted by Farmer in the Dells (WI) on July 10, 2003 at 10:06:29:
I would inspect the spart engine carefully, stored for 10 years, you never know. If it was in a stable temperature dry place maybe. It could be stuck by now if in a damp place or changing temperatures. Did you turn it over from time to time? Did you pour oil into the cylinders from time to time? Check it carefully. The running engine. If the clutch isn't slipping, I wouldn't worry about it. They last a long time if you don't ride them. Grease the throwout bearing once a year or so and don't worry. The front seal is easy if you support the front of the tractor and take off the front end stuff. Even if you have to pull the head and have it done, that isn't hard with the hood off. Get a reprint of an AC service manual. As for removing the engine , if you support the rest of the tractor it too isn't hard. If you do replace the clutch the only thing to do is to make sure the clutch plate is lined or centered when you bolt the clutch pressure platae to the flywheel, you need a dummy clutch shaft to do this, make it out of a wood dowel. Turn it to fit the pilot bearing, then the inside of the spline in the clutch disc, use it to line up the clutch disc as you bolt up the pressure plate. The closer you get it the easier time you hav getting the engine to slide onto the real clutch shaft in the torque tube later. You need a way to lift the engine and then roll the back of the tractor away from it. It helps if you do thes on level paved surfaces, but smooth level dirt or garvel is ok too. Be very carefull if you try to remove the engine and front end as an assembly, it is very unstable. Better to do it is peices especially as you need to get to the front seal. Ask here if you have more questions. Or go over to the orange page.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|