Tractor Talk Discussion Board |
Problems removing axle housing from Case V !!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on July 24, 2003 at 04:44:24 from (209.47.89.111):
I posted this over on the Case forum but nobody responded so I'll try here. Tried to get one of the rear axle housings off my Case V (not a VA) since I've got to get into the brake assembly inside. Got all the big bolts (8) off holding the housing to the tranny/differential housing. Then removed the outer bearing retainer plate on the outside end of the axle housing. There's a seal and shims in there too. My manual (a generic all-model Case manual by Motor's Truck and Tractor Repair) is somewhat vague on the instructions. It says the whole housing should slide right off after undoing the bolts but I get about 1/4" then I can't get any further. I believe the whole outer half of the disc brake assembly should be coming with the housing too. I'm not sure of the bearing type on the outer end of the axle shaft. Should this thing slide right off or is this a normal problem in removing such a housing? Is anything special supposed to be done to the outer bearing or the brake linkages or adjustment bolts before this whole thing slides off? In any event, I'd sure appreciate it if someone that has gone through this could contact me here or at my home email (I've removed the 'hide' on my email link). I could sure use some help and advice. There doesn't appear to be a real detailed shop manual available for the V, at least I haven't been able to find one.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|