Tractor Talk Discussion Board |
Re: What's Your Restoration Cost?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom on August 07, 2003 at 19:28:04 from (12.86.233.38):
In Reply to: What's Your Restoration Cost? posted by Nathan on August 07, 2003 at 13:33:53:
Depends upon your definition of "restored". Some people just fix the obvious things broken, paint, and call it "restored". To other people restored means every moving piece disasembled, inspected, reworked, repaired or replaced if any wear from original specs. Most folks don't do that. You are looking at $10,000 per tractor and up if you really put them back into "new as it left the factory" condition. Just to restore the lower end of the engine would require: turned crank, balanced crank, main bearings, rod bearings, rods, wrist pins, pistons, rings, sleeves, etc. Camshaft turned, balanced, etc. Oil pump rebuilt, water pump rebuilt, radiator rodded out or re-cored, new wiring harness, etc. etc.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|