Tractor Talk Discussion Board |
OT - Picture comments.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Deas on August 22, 2003 at 12:46:18 from (202.138.16.62):
Hi, Folks. Just a note about a comment posted on a picture that I put on 'Stuck & Troubled' a few days ago. The picture is of a large quarry/mine type dump truck that has run over a much smaller 4 wd vehicle. This particular comment asked, "Where do they get the morons that drive this stuff?" (The poster didn't specify which 'stuff' but from the tone my guess is he meant the dump truck driver. I could be wrong.) Firstly, in almost ALL of the places where such large machines are used the MAIN traffic rule is that the machines have right of way at all times, with the possible exception of emergency vehicles. Secondly, you could drive that 4 wd vehicle -- or could before it came to grief -- all around that dump truck close in to it and the only time the dump truck driver would be able to physically SEE it/you (Other than in his rear view mirrors.) would be as you drove past under his driver's side door. Given that visibility is that limited around these things, I would have thought it would be plain common sense (Which sadly seems to be getting less and less common.) to STAY OUT OF THEIR WAY. You can see the picture in question at the link below. There are a couple of other similar photos on 'Stuck & Troubled' too. Just my 2 cents. You have a wonderful day. Best wishes. Deas Plant.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|