|
Tractor Talk Discussion Board |
Re: hydraulic spool valve o rings inside
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kennyp on August 28, 2003 at 19:39:56 from (204.32.206.244):
In Reply to: hydraulic spool valve o rings inside posted by rod on August 28, 2003 at 18:54:19:
Yes, if you change the depth of the pressure plug, you will change the pressure. Some times it is kind of bottomed out so it would go back the same place Not too hard to adjust when you get done. Its been a while since I had one apart so my memory is hazy. If I remember right the hard part was inserting the spool with the O rings on it without scratching them. I think, I placed the ones on one end, them pushed the spool though and put the ones on the other end and pulled it back. To keep from having the O rings in the middle passage which has sharp edges. Go slow and think, and you should have no problems. Kenny
Follow Ups:
Home
| Forums
Today's Featured Article -
An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
