Tractor Talk Discussion Board |
Re: Question about what happens when the throttle
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rob on September 09, 2003 at 14:22:38 from (142.165.119.135):
In Reply to: Question about what happens when the throttle clos posted by Ron on September 09, 2003 at 13:02:15:
Are you talking gas, diesel or something like the old IHC's that started on gas and switched to diesel? Engine speed is controlled by throttle opening in both gas and diesels (but for different reasons) and has nothing directly to do with cylinder pressure. I'm not sure what you're asking. I think you might be confusing compression "pressure" with compression "ratio". Pressure is what you get using a compression tester gauge. It's somewhere around 150-175 psi in gas engines. Compression ratio is swept to unswept volume or the volume inside the cylinder and combustion chamber @ bdc versus the volume @ tdc. It's the ratio (e.g. 20:1) of those volumes. Diesels have much high ratios in order to cause the fuel to ignite due to the high heat caused by the compression. This effect in gas engines is pre-detonation or pinging. Now I'm confused!
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|