|
Tractor Talk Discussion Board |
Re: Bleeding Fuel Lines
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on November 07, 2003 at 12:13:38 from (65.178.201.135):
In Reply to: Bleeding Fuel Lines posted by UpHere on November 07, 2003 at 11:14:30:
You need to bleed the system IF you get air in it. If you pre-fill new filters carefully with clean fuel, you should be able to replace them without bleeding the system. There should be a hand primer on the system so you can pump it up before starting. Pump until the air bubbles disappear, just like you would if it lost prime during a long period of non-use, or if the check valve is bad. Might also help if you motor the engine with the compression lever out, so it won't start- then after a few seconds, push the lever in and let it start. If it runs smoothly, it's ok.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
