Tractor Talk Discussion Board |
Re: Want to Talk to Experienced Engine Rebuilder
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by raytasch on November 23, 2003 at 18:28:35 from (209.165.11.97):
In Reply to: Want to Talk to Experienced Engine Rebuilder posted by moonlite on November 23, 2003 at 16:31:13:
I, too, have heard the stories about not going less than .030 under. I've heard the hardening stories. I have seen low speed engines run with .060 undersize and do well for many hours/years. I have in my shop two sets of Federal Mogul bearings for a Ford N engine that are .060 under. Main# 567 M 60 and rods are 1055 CP60. Going .060 under is not my idea of the ideal situation but I figure someday I or someone will be glad to use them. ray
Follow Ups:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|