Tractor Talk Discussion Board |
Re: John Deere A or Farmall H?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on December 02, 2003 at 05:22:12 from (66.133.133.48):
In Reply to: John Deere A or Farmall H? posted by Martin Miller on December 01, 2003 at 13:52:10:
OK Martin , I'll give you my opinion. I've owned 3 John Deere "A"s , and have run my uncles "H" many many hours. The "A" will no doubt have more power/traction. Quite a difference when actually useing the two tractors. Lets start with the "A". For brush hogging , depending on what the conditions are , you will go through more shear pins , should you have shear pin protection on the brush hog. You will use more gas , and your ears will hurt/ring by the time your through. The john Deere also has a fast reverse. The only thing the fast reverse is good for is backing up distance. Snow plowing is a good example. Pros and cons about hand clutch. On the plus side , the "A" has better brakes , and much better gear selection. I personally like the "A" better. Now for the "H". The "H" is an all around , more user friendly tractor than the "A". It may be smaller , but will still do a good job brush hogging. Slower , more powerful reverse. More control in reverse. The forward gears are what I hate the most about the older farm-alls. Not a very good selection of gears. All gears , except for 5th , are slow. Fith is fast , with little power(not that the "A" is a power house in 6th). The "H" is easyer on the ears , shear pins , and gas. All in all , I think the "H" would be the better choice. And I'm not a farm-all fan.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|