Tractor Talk Discussion Board |
Re: Re: Is there any money is portable sawmills?.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by VaTom on December 03, 2003 at 15:22:13 from (64.4.123.59):
In Reply to: Re: Is there any money is portable sawmills?. posted by Mark on December 03, 2003 at 13:06:13:
Absolutely! As a consumer who hires portable mills, the first guy I used told me that I paid for his mill. Of course he put in more than a few hours getting it. Around here it's not uncommon to hear guys charging $50-60/ hr. At that rate I'd be tempted to buy a mill, but my current guy is only $30/hr for a $35k mill. My interest is selling lumber, not sawing. Now is where we get into profitablity or not. I have a tractor that cost $7.5k and gets me $55/hr. Operating cost is higher than a mill but my overhead is much lower. Lots of work available, but I'd not be inclined to shell out $35k for a $30/hr return. Your mileage may vary.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|