Tractor Talk Discussion Board |
Re: MF Super 90
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mike on December 24, 2003 at 21:14:55 from (67.0.150.152):
In Reply to: MF Super 90 posted by Walter Mott on December 22, 2003 at 11:54:54:
check to be sure the push rod is seated in the lifter and not on the block around the lifter. Have seen this happen more than once. Have seen bent pushrods and broken rockers because of this. When the piston reaches the top of it's stroke and hits the valve held partially open because of this it will sometimes bend the valve stem. You can remove the "stuck" pushrod and use a piece of stiff wire such as welding rod with the flux removed and put it on top of the lifter and crank the engine with the fuel shut off while pushing down on the wire to determine if the lifter is actually stuck or moving.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|