Tractor Talk Discussion Board |
Re: OT: high efficiency furnaces, would like opini
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed Hotaling on January 11, 2004 at 08:13:36 from (199.232.76.250):
In Reply to: OT: high efficiency furnaces, would like opinions posted by KURT (mi) on January 11, 2004 at 03:23:09:
I worked in the HVAC business for more years than I care to remember. When the high efficiency furnaces first came out, the folks installing them tried to do it the same way as they did the old 50% efficiency units. The reason they got a bad rap is that the installation instructions have to be followed TO THE LETTER or you will have trouble. Even the ones with big design flaws run well if installed correctly. As for your specific problem, that can happen with any furnace, regardless of design. It sounds like you have an old-school service man. The old school guys I worked with tought me a lot, but I had to learn to follow mfr's instructions on my own. That said, I had more trouble with 80% furnaces because of flue condensation. Again, the installation makes the difference. If the guy hooking it up thinks he's still working in the 1960's, you will have trouble. If the installer does it right, any hot air furnace should last between 15 and 20 years with regular maintenance (above all else, KEEP THE FILTER CLEAN!!). Of course, everyone makes a stinker and there are a few that will go on for ages. If you do change to a low-efficiency furnace, make sure the flue is installed EXACTLY as the instructions say or you will be very dissatisfied with it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|