|
Tractor Talk Discussion Board |
Re: Tandem Wheatland Tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on January 14, 2004 at 18:04:16 from (152.163.253.66):
In Reply to: Tandem Wheatland Tractors posted by Rauville on January 14, 2004 at 16:12:17:
Back in the late 1950s to early '60s, there were several farmers in central Indiana putting tandem row-crops together. I can remember going to the Indiana State Fair and seeing 4 or 5 each year of various types and setups. A couple of years ago, there were was a tandem set of Allis WD45 units in the antique tractor display at the fair.
My Dad had a friend who did tillage work for several years with two Farmall M tractors in tandem. The front one had live hydraulics and he used a cylinder from that one to operate the clutch on the rear one. About the same time, there were also several farmers in this area who experimented with "furrow-followers" for operating a plow tractor with nobody on board. An arm extended forward of the tractor with a double-disk unit that allowed it to follow the furrow and steer the tractor. A kill-switch was built into the setup that shut off the engine if the front of the guide raised enough to leave the furrow. Controls for the clutch, throttle, and ignition were extended to the back of the plow, allowing the farmer to approach from the rear and stop the tractor. When plowing a large field from the outside to the center, the farmer could be on a second tractor in the same field. This fad only lasted about 5 years or so.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
