Tractor Talk Discussion Board |
Re: Pull the Plug or Leave it?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by fixerupper on February 06, 2004 at 19:53:11 from (206.72.52.5):
In Reply to: Pull the Plug or Leave it? posted by Dan on February 06, 2004 at 12:09:26:
If all else fails you can drill it out just far enough that you don't touch the threads with the drill and then grind down a hack saw blade so it will fit up in the drilled out hole. You cut with the teeth pointing down so you are pulling down to make the cut. Make two slots in the plug opposite each other but quit when the saw just touches the threads and then try to chisel on what is left of the plug to collapse and loosen it. Sounds like a lot of work and it is. It's not especially fun to do but it will work if nothing else does and it will save the threads in the tank. My gut instinct tells me you will end up trying this stunt.
Follow Ups:
Home
| Forums
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|