Tractor Talk Discussion Board |
Re: Re: Air filter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on February 10, 2004 at 07:21:51 from (12.4.181.2):
In Reply to: Re: Air filter posted by Dave_Id on February 09, 2004 at 17:36:54:
Dave - Actually the oil was supposed to be sucked up into the steel mesh in operation and the air was supposed to leave the dirt on the mesh as it passed thru. As the oil drained back into the cup the dirt was supposed to drain back with the oil. But since a percentage of the oil never drained back some of the dirt remained on the mesh. While running at steep angles it's totally possible that unfiltered air could be drawn thru the oil bath filter. And in some oil bath air filters I've seen You can pretty well see right thru the steel mesh it's so coarse. I have an IHC service pamphlet at home that states oil bath air filters are only about 90% effective at removing dirt, while dry pleated paper filters are 99+%. Oil bath filters don't work well with turbochargers either, the oil tends to get sucked right thru them. The fact that tractor engines now run 10,000 hours or more between rebuilds and 30-40 yrs ago You were lucky to get 3000-4000 hours proves todays oils & filters are much better. It is possible to have "New, Improved, Easier to Use, and Cheaper" in some things
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|