Tractor Talk Discussion Board |
Re: Ring job?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CRUSADER on March 07, 2004 at 20:09:33 from (216.31.11.119):
In Reply to: Ring job? posted by Kennyp on March 07, 2004 at 14:21:56:
Hello Kennyp, It's been a few years, but I have done exactly what you are inquiring about doing. Prior to making the decision, I would do like the others that have replied and mic each of the cylinders. If the tolerance will allow, you should be able to get by with using a ridge reamer to cut the wear groove and replace the rings. The Std/.10 ring should work. Be sure to check to ensure that the valves faces and seats are good and lapped in properly. This is (if memory serves me correctly) a dry sleeved engine. At least the one I ringed was. You should be able to get the the gaskets, inserts, ring set, and most other parts you would need from your local NAPA Auto Parts Store. But I would check around to see if there is another supplier which may also have them with the same quality and better price. Good luck with your engine ring job. Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|