Tractor Talk Discussion Board |
Re: Re: In Need of Information on Magneto....
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on April 10, 2004 at 00:44:25 from (195.93.34.11):
In Reply to: Re: In Need of Information on Magneto.... posted by Keith on April 09, 2004 at 21:16:03:
Keith, If you operate without a condenser, the points will spark and the high temperature will oxidise or burn your contacts - keeping them apart by that film or tiny deposit. Reduced current will quickly/immediately lead to no spark at the output. That is precisely why that component is fitted to the system. I have not had a condenser failure on one of my mags yet. Instructions with all(?) hand-start tractors impressed the owner NOT to 'swing' the engine over to try to start it, but just to let the impulse coupling do its job as a better spark is obtained that way. If your engine has one, make sure it is working properly. You do not tell us what mag or engine. There are better makes/models of mag, different types (moving coil or moving magnet). Some are inclined to losing magnetism more than others (and giving less current could be your problem). BUT, generally, the problem is keeping the breaker points clean and gapped exactly as the instructions. You also need to remember not to use resistor type components in you system (carbon fibre leads, resistor type plug caps)and to keep the plug gaps at, but not much more than, the specification, not to fire into an open circuit, even if you have checked the internal safety gap is operating OK. If the breaker cam is worn, it could possibly be opening the points at a time when the generated current is not at the maximum. Other problems can be encountered by not knowing how to put them back together timed correctly if they are adjustable for both rotations. I use American Bosch revolving magnet mags mainly and have very few problems with them. Regards, RAB
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|