Tractor Talk Discussion Board |
Re: john deere 70
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scotty on May 20, 2004 at 13:51:14 from (68.58.25.78):
In Reply to: john deere 70 posted by dave on May 20, 2004 at 12:52:34:
Crankcase should hold 11 quarts! (according to I & T shop service manual # JD - 10). There is a drain plug on the bottom of the Oil Pan that has a brass seal ring on it. The nut takes a large wrench (I think about 1 1/4 - 1 1/2" by memory). The oil change is more effective if You run the tractor for several minutes at a higher RPM to get the dirt mixed up in the oil, & drain it warm, or hot! I always refill the air cleaner while I am at it! The nut to remove the oil filter is located on the bottom close to the oil pan. It has a round protruding lid about 6" +/- across with a nut in the center. Be careful when removing!!! I cant tell You how many times it fell in a 5 gallon bucket, & splashed all over me! The filter popps straight down. The gasket will probably be stuck in the grove that the lid fits in!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|