Tractor Talk Discussion Board |
Re: OT New home wall thickness
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on June 12, 2004 at 13:36:23 from (63.175.91.53):
In Reply to: OT New home wall thickness posted by Kent on June 10, 2004 at 18:09:16:
I just built a new house last yr. Built this house to maintenance free and low operating costs. Pumped extra $$ into high efficiency items now while we are both working with the thought that when we retire/quit/layed off our income will not be consumed by utility and maintenance costs. We followed alot of the EnergyStar recommendations. We built with 2x4s. We put foam boards then fiberglass batts over that. My walls are R30, cieling is R50 (blown insulation over batts). We did all the foam board installation and contractor did the batting. We also did the interior wall insulations for noise reduction including the ceiling/floor between upstairs / downstairs. Lots of caulk and weatherseals, including TYVEK. Also used a good latex paint. Hi-efficiency windows are primarily N and S for maximum natural light without direct sunlight. Our house is extremely tight yet we use the windows for venting as well as screen doors. Took a little longer to build but I am very pleased. Our electic in the summer runs ~120.00/mo (N. FL) and in the winter ~50.00/mo. for a large home. We heat with wood and propane fireplaces. AC Units are SEER 17. Wanted to go geo-thermal but could not find anyone with sufficient experience (future plans for this using 2 acre fish pond for heat exchange). We did alot of the sweat equity ourselves which saved us from paying contractor costs i.e. whole home stereo, attics, CAT 5E wired network, dirt work etc. House was truly a collabrative effort as custom builder was preparing for retirement and our house is WAY out in the boonies - permitted some extra time for some of the amenities we are blessed to have. Check out FOTKI.COM and query for ShepFL. Subscription was just renewed last week.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|