|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Benefits of higher compression?.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron on June 27, 2004 at 03:05:35 from (69.179.4.15):
In Reply to: Re: Re: Re: Benefits of higher compression?. posted by Neil on June 27, 2004 at 00:04:40:
The problem with theories is that they aren't real. For example, aeronautical engineers use certain "theoretical formulas" to determine flight characteristics. Problem is, according to them, bumblebees cannot possibly fly. Good thing the bumblebees don't know that! Remember that the next time you fly; these are the same guys that designed your airplane. Even back in the '60's during the muscle car era engineers got 10% torque improvement per point of CR increase. Like I said, it's a very general rule, subject to lots of factors. One factor that entered into this that 104 octane gas was available anywhere. As you moved up the CR scale, you got those excellent gains because the high octane prevented knock and therefore power loss. There were some muscle cars than ran CRs as high as 11.5:1. Another example: the perfect blower motor has a static CR of 8:1 or so. By adding 6-8 lbs. of boost, most supercharger manufacturers will claim a 30% boost in torque... and it just so happens that 6-8 lbs. of boost raises the combustion pressure to about the equivalent of an 11:1 compression ratio. Remember, engines don't "see" compression ratio. They see cylinder filling and therefore combustion pressure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
