Tractor Talk Discussion Board |
Re: John Deere B(1949)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon C- Florida on August 05, 2004 at 03:12:57 from (66.209.40.192):
In Reply to: John Deere B(1949) posted by Dave59634 on August 04, 2004 at 20:00:12:
Dave - actually its a common problem with this tractor. TimFL, is correct, in my opinion as I have had several B's abd A's with the exact same problem. The only thing holding the gravity feed fuel back is a little needle valve seat in the float bowl. If the float is sticky, or has a leak or the valve seat has the smallest of crud on it, or needle misaligned, the gas will get through. As it slowly gets through, it goes in the carb throat, into the rocker arm/valve cover, and through any valve that is partly open into one or both cylinders. Then, through the rings it will go, trickling slowly into your crankcase until the fuel tank is dry. So if you run the tractor every day, you may not notice it, but after a week or so, the cumulitive effect will surprise you when you have miraculously "made oil". You need to fix the carb. And you need to get into the habit of shutting the fuel off at the tank every time.....assuming the shut off works well.....which should also be checked. Drain the oil/filter and start fresh....the tractor will be fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|