Tractor Talk Discussion Board |
Re: Roosa-Master Gave it Up?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on August 08, 2004 at 18:02:50 from (142.177.83.77):
In Reply to: Roosa-Master Gave it Up? posted by txblu on August 08, 2004 at 08:17:06:
Hope all works out well for you, but that still sounds strange to me. In my exp. if the filter is bled after a filter change (don't crack the bleeder on the pump), they will start, and there will never be a problem. If there is any air in the line, then they must be fully bled. Either starts and goes fine till next time, or doesn't go at all. There is no gettin to the field. I have had air leaks though, and notice this more at idle. Will surge up to about 1000 rmp for a second, then back down, once a minute or so. Could be a line, or sometimes just the gasket on the filter. Hope it's not your problem, but I would watch close on that metering valve.... or other internal problems. FYI that pump should be a CAV Lucas model DPA. Take care. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|