Tractor Talk Discussion Board |
Borrowing 28 GPM of hydraulic oil from 806
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dfarmann on August 18, 2004 at 20:22:56 from (4.158.42.144):
I need to borrow 28 GPM of hydraulic oil from the trans/rear end of my 806 and draw it threw a inline filter and on to a Vicers pump being run off the 1000 RPM PTO shaft and on to a Backhoe attachment. I am stuck on what is the best location to get the oil from. The largest drain fitting in the bottom of the castings is ¾” NPT, can I draw 28 GPM thru a 3/4” NPT nipple? The rest of the plumbing will be 1”NPT. If ¾” isn’t large enough, how risky would it be to Drill out the Casting and Tap it to 1” NPT? (I don’t want to do this). Or can I remove the Filter Cover and drill a hole big enough to Weld in a 1” NPT nipple to get the flow I need, and would it make a difference where on the Cover this was done? TIA! Dave
Follow Ups:
Home
| Forums
Today's Featured Article -
A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|