Tractor Talk Discussion Board |
Re: How do you polarize the generator?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon C -Florida on September 08, 2004 at 17:39:49 from (66.209.40.195):
In Reply to: How do you polarize the generator? posted by Wil on September 08, 2004 at 09:08:49:
Wil - To Polarize the generator, just take a short piece of wire, and short accross the "BAT" on the regulator to the "GEN" or "ARM" post of the generator, without the tractor running. It should spark when you do this. The "BAT" terminal / wire should always be hot. Assuming the tractor is wired correctly you can bypass the regulator to make sure the generator is charging by doing the following: First: You have to have a good ground with both the generator AND the regulator. Use your meter to make sure you have both well grounded. If in doubt, run a dedicated wire from your battery ground to the regulator case. Also, make sure you have a hot battery, and the belt is tight. Next: Polarize using method described. You should get a spark when you do this. If you don't something is wrong. Next: With engine running, ground the field post to a good ground and see if it charges on the ampmeter. Next: if it still doesnt charge, leave the field post grounded and jump the V.R. "BAT" to the generators "GEN (or "ARM") terminal. This completly bypasses the V.R. and if the generator is working, you should get a good positive charge on your ammeter. If it still doesnt charge you have incorrect wiring, or a bad generator. If it does charge, the problem is likely in the V.R. If you re-wired the tractor recently, and the polarizing did not do it, you may have to reverse the wires on the ammeter. Post back and let us know.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|