Tractor Talk Discussion Board |
Re: Radial vrs. Bias Ply
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on September 17, 2004 at 07:13:55 from (142.177.98.167):
In Reply to: Radial vrs. Bias Ply posted by Mark - IN. on September 17, 2004 at 06:08:10:
Mark, In my experience, radials wear better, pull better, and ride better. Tire companies also claim that you should also see improved fuel efficiency, but I haven't seen that, but then I added more weight and rack travel when the tires went on, so I didn't expect to see an increase in fuel efficiency. I do know this: Goodyear Dyna Torq II bias tires as well as Firestone Field and Road would last me 2000 hours for the work I do, with a lot of road miles. I now have Firestone 23 degree radials, which now have 2000 hours service and are still 50 %. They were cheaper than Micheline and Good Year radials in my area. I thought the others were just too much money to pay for themselves, but the Firestones have, as they were only about 150 more each than the bias tires. Goodyear radials were near double the price of a bias tire. Just remember the cost of buying new radial tubes, as the bias tubes don't work in radial tires. They are not much more money, just the fact that you need them even if the old tubes are still good. Radial tires flex more in the sidewall, rather than in the tread, and that is harder on tubes. For me to buy a radial is a matter of operating cost, unless I need the all out performance of the radial. You can do some math and see if it works for you. HTH. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|