Tractor Talk Discussion Board |
Re: Forum software vote
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john in la on September 27, 2004 at 11:41:04 from (65.6.105.101):
In Reply to: Forum software vote posted by txblu on September 27, 2004 at 08:21:50:
Mark; I asked Kim about the vote on the other forum. She responded by saying that the vote going on now was to see if it was worth her time to install the new software. Since there was enough Yes votes she went ahead and installed it. She said that she will allow us to use and try it out for about a month and then at that time will start a new vote to see if we want to keep it. Personally I like the little picture thingy and the address or location line. But other than that I am happy with the old set up. I can see what I have read and not read easier. Kim also said that she could take good points of one software and add it to the other software if we would like. Think that is what we will wind up with in the long run. It will take a large vote to find out all the particulars of what we like but in the long run we could have the best of both worlds. That would be extra work for Kim but she has said she may do it. My vote still goes to what ever is best for KIM. Thanks Kim for making this site even better.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|