Tractor Talk Discussion Board |
Re: 3 angle valve grinding??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jdemaris on November 12, 2004 at 19:13:44 from (209.23.28.181):
In Reply to: 3 angle valve grinding?? posted by Lynn Kasdorf on November 12, 2004 at 13:03:22:
I'll try not to be redundant here and repeat what has already been said. I first read about "three seat" valve jobs back in the 60s in a racing magazine and never quite understood what they were talking about. I was wondering if they were actually making three valve seats instead of one - or just came up with new terminology to make standard procedure sound like something new. I still don't know. If you put a new valve seat insert into a head (or block for a flathead)it may be narrow enough where there won't be three angles. But, after grinding - or carbide cutting seats, they get wider - and thusly have to be narrowed back to specs. And, that's for at least two reasons. Number one, already discussed, is to get the correct width for valve cooling. This is especially critical in an air-cooled engine. Second - is to get the correct pressure on the valve seat. The spring on the valve provides closting pressure, but, if the valve seat is too wide - the pounds per square inch is lessened on the valve face and seat. As far as valve-lapping compound being obsolete, I disagree. A properly machined valve face and seat don't need lapping for proper seal - but a light use of lapping compound works kind of like Prussian Blue as a marker and lets you see exactly where the sealing area is. Sometimes, with a freshly machined seat and valve face, it's hard to see for sure. Lap it a little, and the sealing area gets dark and lets you see for sure. It takes a little extra time, but it sometimes exposes mistakes.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|