Tractor Talk Discussion Board |
Re: OT, putting in a driveway
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Midwest redneck on November 16, 2004 at 14:18:01 from (64.136.26.225):
In Reply to: OT, putting in a driveway posted by Joeeey on November 16, 2004 at 10:07:52:
I have a 900' long driveway, flagpole lot. I had an excavator rip up the top 6" of soil then I had 4" of fill sand laid in and then 4" of 1X3 limestone (the bigger rock) and I had the concrete trucks from the house and garage construction drive over it many times coming in and out. then after I was all done building I put 3" of small crushed limestone over it to cap it off and make it look good. I dont regret it one bit and it cost me about $9000... material and labor. My neighbor put down the geotex fabric and paid $1000 for it and laid limestone over the fabric and his driveway is full of ruts and will not hold 40ton trucks because there is not enough compacted material below the stone. Good Luck
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|