Tractor Talk Discussion Board |
Re: Oneway's/ Disk tiller's
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. on December 21, 2004 at 20:19:27 from (65.161.170.30):
In Reply to: Oneway's/ Disk tiller's posted by R Wyler on December 21, 2004 at 18:56:31:
R Wyler, My Dad bought a brand new tiller seris 8ft cut oneway plow in 1968 This one had the Stinger wheel (coulter) instead of the heavy weighted angles tailwheel. Going from an old IH 5ft cut to this 8ft cut rig was a major jump in work getting done. Easier to set, run corners, and change for transport was a joy. It was all rubber tired, unlike the steelwheel thing we parked. It was a single shaft of 12 or 14 disk. A little over 8 ft long. Now, don't confuse the subjest by thinking that damm Surflex-tiller series is what I am talking about. This plow is IMOSSIBLE to set, make plow, it ridged, was allaround piece of junk!!!!!! one of Deeres worst ideas. It had sections of 5 or 6 disk / section. A 3 section plow was about 15 ft cut. The trick was to set it so all sections plowed as if it were one unit. It was meant to compete with the Krause 14 to 20 ft flat land oneways Hope this helps. Later, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|