Tractor Talk Discussion Board |
Re: OT: Tips/ideas for pole barn, do's/dont's.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Cliff Neubauer on December 27, 2004 at 15:10:04 from (69.18.16.235):
In Reply to: OT: Tips/ideas for pole barn, do's/dont's. posted by Markss on December 26, 2004 at 09:07:03:
We have at least 13 (I may be forgetting one) pole buildings that range from cheap lumber yard buildings to Morton buildings and from what I've seen the lumber yard buildings are holding up at least as good as the Morton's. If you are thinking of adding on the to building when you can afford it then I would built it as wide and tall as you can afford now, even if you had to go 40x40x14' you can add a lean to on each side as well as build onto one end when the time comes. If I was to put up a new wood frame building I think I would start out with at least a 12" concrete wall and then use three 2x6"s sandwiched together with the truss between them for the poles. This way the poles will never rot off and it will be easy to pour a cement floor in later. To attach the siding just place 2x6s horizontally on 24" centers between the vertical post which will also allow cheap batt insulation to be used. I would talk to other farmer's in your area to see what buildings and builders they have been happy with. All of our buildings have sliding doors and I hate every single one of them, when it snows you have to keep them dug out and even on windy days they can be tough to handle.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|