Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: starting fluid and diesel motors


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by buickanddeere on January 06, 2005 at 06:11:53 from (64.10.41.126):

In Reply to: starting fluid and diesel motors posted by ryan goss on January 05, 2005 at 22:22:46:

Ether knocks because of it's low octane which means it has a "low" ignition temperature. That's the idea when compression heat isn't enough to light fuel oil but will ignite the ether.
High enough detonation/kocking pressure will pound bearings, bend rods or crush/pinch/break piston ring lands
As for being "dry"? yes ether is one of the best oil solvents. The engine shouldn't get enough ether to remove significant ring/bore lubrication.
Ether has a very low vapour pressure/temperature where the non burnable liquid will turn into a burnable vapour when mixed with O2.
So in cold weather, ether is in a physical state ready to burn and to ignite easy.
As previously stated. TOO MUCH or used with PREHEATERS/GLOWPLUGS is looking for a repair bill.
Ether is a poor substitute for rebuilding a set of injectors in need of service.
If at all possible synthetic oil, winter weight mineral oil or a oil pan heater. Or that cold engine will start and run without sufficient lubrication.
The block heater and battery heater are the hands down winner if at all possible. Even if it will start at below freezing temps without the block heater. Use the heater anyways. Less wear on the entire electrical system, less engine wear and reduced fuel consumption.
Have to wonder about those people with that block heater cord wrapped up unused under the hood. As they burn how much fuel & wear while idling in the driveway for 10-20 minutes to warm up.
Plug in a few cents of electrical heat. That defroster will be blowing heat right after starting before you get the windows scraped clear.


Follow Ups:




Post a Followup

:
: :

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli ... [Read Article]

Latest Ad: 1945 Farmall wide body gas with pto and front plow. Runs good but needs new points. [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy