Tractor Talk Discussion Board |
Re: Previous accident photos
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Errin OH on February 22, 2005 at 14:39:29 from (198.57.19.122):
In Reply to: Previous accident photos posted by dr.sportster on February 22, 2005 at 14:23:31:
Doubt either came all way over, fliped on side then on top. You can see where the bale was sitting on the JD. The other looked some what the same deal. How would you flip one with a blade on the back? Be on he!! of a ride if ya did. What'd they do wrong - probably nothing they haven't done a hundred times before. I would be guessin but a heavy low hung counter weight might have help prevent both. Keep the back end down. Guessin again what most likely contributed was uneven ground raising or lowerin one rear wheel vs the other. Then it'd be a matter of gravity (as in center of).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|