Tractor Talk Discussion Board |
Re: OT: Generators in series?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FarmerDave on March 10, 2005 at 20:03:35 from (208.207.98.48):
In Reply to: OT: Generators in series? posted by JistThinkin on March 09, 2005 at 18:24:43:
You need some way to get them in phase. Other than the phase problem it would work fine. AC voltage is modeled as a phasor. Think of this as say a 120 inch( volt) stick that spins in a circle. Let's say it spins counter clockwise. So East, North, West, South, back to east. As the stick goes up the voltage rises to 120V. Then the stick goes down to west and zero volts. Now the stick goes to south or -120V. Then it comes up to east at 0V. If one generator is at north and the other is at south they cancel each other out. If both are at north at the same time 120V + 120V is 240V. I suspect if you were good at motor/generators you could make it work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|