Tractor Talk Discussion Board |
Re: Using Propane for Cutting Torch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike-UT on March 30, 2005 at 06:54:02 from (207.168.80.180):
In Reply to: Using Propane for Cutting Torch posted by 37 chief on March 30, 2005 at 01:04:56:
You can get propane with a "hot mix" in it that will cut lots faster than propane. It costs a little more, but lots cheaper than acetylyne. I used to use a product called "Chemolene". Ask your local welding/gas shop. It and propane will outlast acetylene by at least 5 to 1. A real benefit of propane and/or Chemolene is that since there's no carbon in it, it won't leave any slag to grind off! What little it does leave you can chip it off with ease. It's a real benefit on a burn table too since it doesn't leave slag. One drawback is that you can't gas weld with it as there's no carbon in it to make it stick! You also don't have to worry about the tank being upright like acetylene. You can crank the oxygen up as high as you want. It works great with a "Rosebud" and A "Gouger" too. With a size "0" tip you can easily cut 6 inches of steel.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|