Tractor Talk Discussion Board |
Re: Oil Pressure problem-John Deere
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Ghormley on April 09, 2005 at 10:26:42 from (192.31.106.36):
In Reply to: Re: Oil Pressure problem-John Deere posted by buickanddeere on April 09, 2005 at 10:01:43:
I will try to close off the oil pressure adjusting valve as much as possible. It has a spring and a small little piston looking valve at the end of the spring that is about 1/2" x 1/2" in diameter. I will cut a small piece of pipe to put between the spring and the valve to increase the tension of the spring on it. I think I want to also try in a different test to fill up the crankcase with more oil to see if there is a problem with the oil flowing back into the crankcase. I am still wondering if something isn't caught or stuck in an oil passage or in the screened in pickup tube connected to the oil pump. I wasn't able to get into the screen covered looking hockey puck size pickup for the pump and clean it really well. It looked fine but maybe there was some junk in it that I didn't see. Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|