Tractor Talk Discussion Board |
Re: oliver
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txgrn on May 06, 2005 at 05:33:15 from (209.151.114.176):
In Reply to: oliver posted by harry771 on May 05, 2005 at 20:32:26:
Too lean a fuel mixture will do it. Open your high and low speed jets a tad..Will have to experiment to get the sweet spot. Don't want them too open or you will waste fuel when running normally, and the engine may not run smoothly (too rich a mixture). Cold eng temp requires a higher fuel air mix than a warm one. That's why you have thermostats on engines. Run more efficiently at around 180 degrees to 200 degrees. Think about this. You choke a cold engine to get fuel thru the carb to the intake manifold. But why do you have to keep the choke partially engaged initially after the engine has fired.....you got it; need a richer mixture. Don't want to get too hot or you have coolant boiling problems and oil breakdown; on the other end you have condensation and misfiring and just a big gooey mess. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|