Tractor Talk Discussion Board |
Re: Old Dodge Truck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by doogdoog on May 14, 2005 at 22:59:30 from (66.8.145.42):
In Reply to: Old Dodge Truck posted by FFAChapter on May 14, 2005 at 21:15:20:
Aloha, I am assuming that you are not using the fuel pump from the engine. If you are just using the boat gas tank, I would fill it up (not to the top)and close the vent and shake the 5 gal can. The gas will expand and fuel should come out of the line. Keep the tank higher than the carb and it will siphon out of the 5 gal can (gravity) and don't forget to open the vent valve.You may also have to open up the line at the carb until the fuel starts to flow out. Another way to do it,is to get one of those siphoning hoses with the rubber ball with a check valve that they use for outboard boat motors. There are many other ways but these should get you started. TIA Mahalo, doogdoog
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|